Remote starter switch hook up

How does a remote starter switch work?

The remote starter switch allows you to turn over or crank the engine without actually running the engine. This comes in handy for conducting certain tests, such as compression or finding the high side of an engine cylinder.

Where are the wires on a remote start relay module?

These 6 wires will be connected to the remote start relay module. The key switch has a connector jack with 3 pairs of lugs. The constant 12volt will always have voltage on it. This is the first and easiest the find. In this car it is the RED and ORANGE wires in the middle of the connector jack to the key switch.

How do you start a car with a remote starter?

Depress the remote starter switch. The engine should now be cranking but not running. Place the vehicle in park and set the emergency brake. Locate the starter on the engine of the vehicle. You may have to crawl under the vehicle slightly to reach the starter motor. Identify the connections on the starter.

How do you hook up a starter relay to a battery?

Place one alligator clamp on the positive side of the battery. This will provide the power to the switch. Place the other alligator clamp of the switch on the small connector of the starter relay. The contacts of the starter relay will then be turning over or cranking the starter.

How does a remote starter work?

In short, remote starters simulate the engine starting sequence you initiate when you turn on the car with your key. However, a remote car starter does this without a physical key in the ignition. This is made possible when the control module is wired into your ignition switch and other starter mechanisms.

How do you start a car with a remote starter?

Depress the remote starter switch. The engine should now be cranking but not running. Place the vehicle in park and set the emergency brake. Locate the starter on the engine of the vehicle. You may have to crawl under the vehicle slightly to reach the starter motor. Identify the connections on the starter.

What causes a remote starter not to engage?

The single biggest thing that can cause a remote starter not to engage is a faulty or missing hood switch. This device gets installed under the hood of your vehicle and prevents the engine from starting when the hood is up.

How does a remote start work on a Compustar?

Wiring in the Control Module Each part of the Compustar system connects to and communicates with the control module to perform all security and remote start functions, much like the motherboard of a computer. On paper, remote car starters might sound simple: insert a box in the car and use a remote to control the box.

How to wire a starter relay?

Here is how to wire a typical four-connection starter relay. Things you will need: pliers, wrenches, and wires ( if they are not provided) Step 1 Disconnect the positive battery terminal. Secure the exposed end to avoid accidents. You may use tape to do that. Step 2 Find the thick starter solenoid cable.

Where does the battery wire connect to the starter motor?

These are the cables that connect the battery to your car’s starting system. First, the red one connects the starter solenoid to its positive terminal. This wire is usually live so be careful when handling it. Then, a black or greenish-yellow cable connects the starter motor to the battery’s negative terminal.

How to wire a starter solenoid to a battery?

Connect it to the remaining big terminal on the starter solenoid. If the wire is not available, use yours and connect it to the positive terminal of the battery. Use the right gauge for the wire, because it will be carrying a large current from the battery. Your wiring is now complete.

Where is the fuse box starter relay on a car?

You can track down the fuse box starter relay by following the big wire from the positive battery terminal. They are located close to the battery sitting in a box with a black lid on most vehicles. How do you check if a starter relay is working?