Chlorinator hookup

How to install in line Hayward chlorinator?

In-Line Hayward Chlorinator Install 1 Shut off pump and open air bleeder to drain pipes. 2 Locate section of pipe to cut, measure twice and cut, twice. 3 Thread 1.5″ adapters (2) fully into feeder, sealing with Teflon tape. 4 Use PVC Primer and Glue to connect pipes to adapters. 5 Fill with America’s Favorite Chlorine!

What is a swimming pool chlorinator?

Swimming pool chlorinators have made it easier and safer to chlorinate your pool water. They are also affordable and manufactured in different sizes for all types of pools and spas. Aboveground pool chlorinators and inground pool chlorinators are available, and installation is quick and easy.

How do I install an in-line chlorinator?

In-line chlorinators must be installed after the filter and after any heater. They should be installed at ground level to prevent back flow, and if you have a heater, a one-way check valve should be installed between the heater and the feeder, to prevent damage from corrosive chlorine gas. Shut off pump and open air bleeder to drain pipes.

How do you attach a chlorinator to a PVC pipe?

Now put glue on the pipe, and on the inside of the chlorinator fittings. MAKE SURE THE FLOW ARROW IS POINTED IN THE RIGHT DIRECTION (towards the pool) Insert the chlorinator and hold straight up until the glue sets.

Can you use Hayward chlorine feeder on PVC pipe?

In-Line Hayward Chlorinator Install Hayward CL100/CL200 are designed for permanent installation to PVC pipe or hose. Both feeders have 1.5″ female threads to connect to a hose adapter (above ground pools), or a 1.5″ male adapter. You can also buy the optional Hayward SxS Unions, connectors to match 1.5″ PVC pipe.

How to install a Hayward Aqua rite salt chlorine generator?

How to Install a Hayward Aqua Rite Salt Chlorine Generator. 1 Step 1. Balance the pool water before installing the Aqua Rite Salt Generator. Note: If the pool does not have new water, add one quart of metal ... 2 Step 2. 3 Step 3. 4 Step 4. 5 Step 5. More items

Whats new in Hayward off-line chlorinators?

For Off-Line models, a new Check Valve & Inlet Fitting ( CLX220EA) is in order every few years, to keep water flowing properly. Also replaceable is the internal standpipe or feeder pipe ( CLX200H ). Stuck Chlorinator Lid: The Hayward Chlorinator has a unique internal o-ring, made of Viton, a chlorine resistant rubber.

How do you secure a Hayward chlorinator to the floor?

Securing a Hayward chlorinator into a concrete floor with anchors and screws is recommended, to hold the body stationary when you remove the lid. An alternate method is to fasten the feeder to a hefty piece of pressure treated lumber that is pegged into the pad. Secure the CL220 feeder to the pad or hefty length of lumber.