Swamp cooler hook up kit

How do I hook up my swamp cooler?

Swamp coolers installed on the ground or side-mounted in a window are the simplest to hook up. You can easily supply water to these units by running a supply line from the cooler to a spigot on the outside of your home. A simple adapter allows you to attach the water supply line directly onto the hose bib for a fast and easy hookup.

Do swamp coolers need a water supply line?

They do need a constant supply of water to operate, however, so youll have to hook yours up to a water supply line before summer weather hits. Swamp coolers installed on the ground or side-mounted in a window are the simplest to hook up.

Where is the best location for a swamp cooler?

The best location for the swamp cooler is on the back side of the roof for aesthetic reasons. This offset configuration is best if the ceiling and roof trusses do not line up, or if it is desired to get the unit more out of sight, or if the ductwork would hit the peak of the roof by going straight up and out.

How do you stop a swamp cooler from leaking water?

Install a shutoff valve on the water supply line leading to your swamp cooler in case you develop a leak at some point in the future. Note that you can do this job more quickly if you use a saddle valve to connect the swamp cooler water supply line to your water heater supply line.

Can you hook a swamp cooler to a water supply line?

Technically, you can hook a rooftop swamp cooler to a water supply line in the same way you would one mounted on the ground or in a window. However, you may have a long way to go from the roof to the ground and then to a water supply.

How do you fix a swamp cooler that wont turn on?

Slide the plastic sleeve and brass nut down onto the threads of the swamp cooler and tighten the nut by hand. When the nut is hand-tight, use a wrench to tighten it another 1/4 turn. Run your irrigation line from the swamp cooler down to the ground if necessary and then run it along your home to the water supply.

How does a swamp cooler work?

Swamp coolers add water to the air to cool it down, raising the humidity in your home. They work best in dry climates. To use a swamp cooler, you first must pick the right one for your home. Then, you can use it as the weather gets warmer to cool your home. Pick between window-mounted, roof-mounted, and ground-mounted.

Are swamp coolers better than air conditioners?

Swamp coolers are also more environmentally friendly than air conditioners since they dont require the use of chemical refrigerants. They do need a constant supply of water to operate, however, so youll have to hook yours up to a water supply line before summer weather hits.

How to fix a swamp cooler that won’t cool?

The copper line or the main water line carries water into the swamp cooler. This line is secured with a thick nut called a compression nut. Use a wrench to tighten the nut. Turn on the water supply. If water is still dripping from the nut, you need to check the washer. Shut off the water supply.

How often should I Clean my swamp cooler?

Your swamp cooler uses water instead of freon to make the cool air. If you live in an area with hard water, you will want to clean your unit every two or three weeks to prevent mineral build-up that can cause your unit to spit water when it shouldn’t. Pro Tip: Do NOT use softened water.

Why does my swamp cooler leak?

Leaks can be caused by the pads due to a variety of reasons. For starters, the pads should be properly fitted. Loose pads tend to deflect the water. Some swamp cooler models have a metallic mesh like structure to secure the padding.

How do I Stop my Water Cooler from leaking?

Tighten the overflow pipe. If that doesnt work, you may need to replace the drain fittings and/or the overflow pipe. Check to see if there is leaking out of the bottom of the cooler housing from the sides of the pad.